查看标准

适用范围：<p>The fire performance of a material or product is affected by a combination of its fire-test-response characteristics. Two of the most commonly determined fire-test-response characteristics of cushioning materials are the surface flammability, in accordance with Test Method <a href="http://myastm.astm.org/SUBSCRIPTION/NewValidateSubscription.cgi?D3675-HTML">D3675</a>, and the specific optical density of smoke, in accordance with Test Method <a href="http://myastm.astm.org/SUBSCRIPTION/NewValidateSubscription.cgi?E662-HTML">E662</a>.</p> <p>Cushioning materials used in upholstery applications are potentially exposed to leaching of the active ingredients due to (<span class="italic">1</span>) water solubility of the treating agents or (<span class="italic">2</span>) exposure to high humidity.</p> <p>In view of the importance that the fire performance of the cushioning materials used in upholstery applications remain constant throughout their intended service life, this test method provides a means to test for the potential change in two fire-test-response characteristics due to leaching.</p><p id="s00002">1.1 This fire-test-response test method covers a procedure for leaching cushioning materials with water and determining changes in two specific fire-test-response characteristics: (<span class="italic">1</span>) the surface flammability, in accordance with Test Method <a href="http://myastm.astm.org/SUBSCRIPTION/NewValidateSubscription.cgi?D3675-HTML">D3675</a>, and (<span class="italic">2</span>) the specific optical density of smoke generated, in accordance with Test Method <a href="http://myastm.astm.org/SUBSCRIPTION/NewValidateSubscription.cgi?E662-HTML">E662</a>.</p> <p id="s00004">1.2 In view of the wide variation in potential service conditions, it is likely that results of this leaching test will not give a direct correlation with service performance for all applications. However, the test method yields comparative data on which to base judgments as to expected service of cushioning materials and is useful in research and development work.</p> <p id="s00005">1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.</p> <p id="s00003">1.4 <span class="italic">This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions. </span></p> <p id="s00006">1.5 <span class="italic">This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. <span class="med">For specific precautionary statements, see Section 7.</span></span> <p id="s00080">1.6 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.</p>